3D protective face mask uses the non-woven fabric and the melt-blown fabric raw materials. Three-dimensional design makes the face mask more fit and suitable for all kinds of faces, elastic earbands provide a more comfortable wearing experience, wearing for a long time without tight and allergic reaction.
The mask uses smooth fabric materials to reduce the fiber drop, waterproof, can better prevent dust and microorganisms, which is convenient, practical, more safe and hygienic.
1. It can filter over 99% of the very small pollution particles;
2. Effectively block suspended particles -- pollens, haze, waste gas and dust particles;
3. Three-dimensional design - fit the face well to reduce leakage points;
4. Low suction impedance, good air permeability, not hot;
5. Wider elastic earbands - wearing for a long time without tight and allergic reaction;
6. One-piece cutting, automatic molding, and mass production is available.
PM- II 9501
Sodium chloride particle filtration
Step1: Unfolded the mask, and distinguish the outer and inner side. The side printed "上" is the upper side;
Step2: Pull the straps and position them below ears to cover the mouth and nose;
Step3: Adjust the top of masks to fit the contour of nose bridge, and check if it is centered;
Step4: Put fingers on the middle of masks, and check the tightness with your cheek.
25pcs/bag, 50pcs/box, 2000pcs/ctn, 60x42x47cm (carton size).