3D Medical face mask are worn on the faces of people in contact with viral materials in medical facilities, to prevent virus transmission from a patient to medical staff. It provides a basic protection for medical personnel or related personnel, as well as the protection against the transmission of blood, body fluid and spatter in the invasive operation, the product is for single use only.
Compared with the conventional flat medical face mask, 3D design is suitable for all kinds of faces and fit the wearer's face tightly, elastic earbands provide a more comfortable wearing feeling, and can allow enough space for breathing.
1. Bacterial filtration efficiency is up to 98%;
2. Outer fabric layer is water-repellent, and inner layer is soft and skin-friendly;
3. Three-dimensional design - fit the face well to reduce leakage points;
4. Low suction impedance, good air permeability, not hot;
5. Wider elastic earbands - wearing for a long time without tight and allergic reaction;
6. One-piece cutting, automatic molding, and mass production is available.
EN14683 TYPE IIR
Step1: Unfolded the mask, and distinguish the outer and inner side. The side printed "上" is the upper side;
Step2: Pull the straps and position them below ears to cover the mouth and nose;
Step3: Adjust the top of masks to fit the contour of nose bridge, and check if it is centered;
Step4: Put fingers on the middle of masks, and check the tightness with your cheek.